To operate the auxiliary lift system
The auxiliary lift system decrease the ground pressure
from the pivot wheel on the cutting deck.
• To decrease the ground pressure, put the gas spring
in 1 of the top holes on the locking plate.
• To increase the ground pressure, put the gas spring
in 1 of the bottom holes on the locking plate.
Note: Put the gas pin in the top hole when you cut
grass.
To adjust the cutting height - Combi
132 and Combi 155
1. Park the product on level ground.
2. Apply the parking brake.
3. Set the lift lever for the cutting deck in the transport
position.
4. Stop the engine.
5. Remove the cutting height adjustment knob on the
side of the cutting deck.
6. Put the cutting height adjustment knob in 1 of the
holes on the adjustment plate.
Note:
The cutting height is shown with the numbers
1-7. Refer to the table below.
7. Tighten the cutting height adjustment knob.
8. Do steps 5-7 on the other side of the cutting deck.
9. Remove the locking pin on the cutting height
adjustment lever in the top left corner of the cutting
deck.
10. Push the cutting height adjustment lever down and
pull the lever horizontally.
11. Put the lever in the hole with the same number as on
the adjustment plate.
Note: Make sure the same number is selected on all
3 adjustment points.
12. Attach the locking pin on the cutting height
adjustment lever.
13. Adjust the parallelism of the cutting deck. Refer to
To
adjust the parallelism of the cutting deck on page
30
.
Number Cutting height, mm / in.
1 30 / 1.2
2 40 / 1.6
3 52 / 2
4 64 / 2.5
5 76 / 2.3
6 93 / 3.7
7 112 / 4.4
To adjust the cutting height - Combi
132 X and Combi 155 X
1. Park the product on level ground
2. Move the lift lever for hydraulic lift forward to lower
the cutting deck to mow position.
740 - 004 -
21
To Next Page
Loading...
