Husqvarna P 520D - Detailed Maintenance Tasks and Intervals; Periodic Maintenance Checks and Replacements

Maintenance
Daily Weekly
Maintenance interval in
hours
25 100 200 400 800
Do a check of the parking brake X
Adjust the parking brake * *
Do a check of the lamps, replace broken lamps X
Lubricate according to the lubrication overview X X X
Lubricate the blade shafts X
Lubricate the front and rear bearings of the lift arms X X
Lubricate the pivot wheel bearings X
Lubricate the drive shaft X X X
Lubricate the throttle cable X
Lubricate the wheel axles splines X
Examine and adjust the wheel nuts * *
Make sure that the tire pressure is correct X X X
Replace the blades X X
Replace the engine oil
1
X
Replace the oil filter
1
X
Replace the oil in the angle gear *
Replace the hydraulic oil *
Replace the hydraulic oil filter *
Replace the air filter X
Replace the fuel filter X
Do a check of the parallelism of the cutting deck X X
Replace the generator belt *
Replace the PTO belts *
Replace the coolant *
Examine the battery X X X
Make sure that the muffler is attached correctly and not dam-
aged
* * *
Replace the engine cushions and the gear cushions *
Do a check of/adjust front and rear wheel speed * *
Do a check of the oil level in the bevel gear X X
Replace the oil in the bevel gear *
Replace the oil in the transmissions * *
1
Replace first time after 25 hours. For heavy load operation or at high ambient temperatures, replace every 50
hours.
740 - 004 - 25