Husqvarna P 520D - Component Removal and Lamp Replacement; Removing Side, Transmission Covers, and Service Hatch; Procedure for Replacing Broken Lamps

To remove the right side cover
1. Remove the 3 screws and remove the side cover.
To remove the service hatch
1. Remove the 2 screws and lift off the service hatch.
To remove the cover plate
1. Remove the 3 screws and remove the cover plate.
To remove the transmission cover
1. Remove the 4 screws.
2. Lift and remove the transmission cover.
To replace a broken lamp
1. Remove the 2 screws, one on each side, and
remove the cover.
2. Disconnect the cables at the connection (A).
A
740 - 004 -
27