66 – English
Replacing the light bulbs
Rider Pro 18
For information about the bulb type, see ‘Technical
Data’.
1. Unscrew the two screws holding the cover on
the power steering housing.
Lift up the cover and turn it around the steering
shaft.
6. Refit the cables, lamp insert and the cover on
the power steering housing.
5. Insert the new bulbs. Make sure you use your
thumb to support the front.
3. Disconnect the cables from the bulbs
4. Lift out the bulbs from the insert.
2. Unscrew the two screws holding the lamp
insert.
Lift out the lamp insert.
Electrical system
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
