Husqvarna Rider 213 C - MAINTENANCE AND SERVICE; Maintenance schedule

English – 21
MAINTENANCE AND SERVICE
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.
1)
If the machine is used daily it should be lubricated twice a week.
2)
Maintenance and replacement are required more often in
dusty conditions.
3)
First change after 8 hours. When operating with a heavy load or at high ambient temperatures, replace every
50 hours.
4)
Replace the oil filter every 200 hours.
5)
Replace the paper filter annually or every 200 hours.
6)
Conducted by authorised
service workshop.
7)
After the first 50 h then every 200 h, or at least once a year.
8)
Only AWD-machines
X = Described in this operator's manual
O = Not described in this operator's manual
!
WARNING! No service procedures must be conducted on the engine or cutting unit unless:
The engine is switched off.
The ignition key is removed.
The ignition cable has been removed from the spark plug.
The parking brake is applied.
The cutting unit is disengaged.
Maintenance
Daily
maintenance
before starting
At least
once a year
Maintenance
interval in hours
25 50 100 200
Cleaning X
Clean the cutting deck, under the belt covers and under the cutting deck. X
Clean around the silencer O
Clean the engine cooling air intake and transmission air intake
2, 6)
O O O
Check/adjust front and rear wheel rotation speed
6,8)
O O O
Checking the engine’s cooling air intake X
Check the engine’s oil level X
Check the fuel pump air filter X
Check the steering wires X
Check the battery X
Check the safety system X
Check nuts and screws O
Check for fuel and oil leakage. O
Check the cutters in the cutting deck X
Checking the tyre pressure X X X X
Check/adjust parking brake X X X X
Check the V-belts O O O O
Check the oil level in the transmission, top up if necessary. O O O
Checking and adjusting of throttle wire X X X
Check the fuel hose. Replace if necessary .
6)
O
Change the oil in the gearbox
7)
O O O
Change the engine oil
3, 4)
X X
Replace the air filter’s prefilter and paper filter
2, 5)
X X X X X
Replace the fuel filter. X X
Change the oil filter X X
Change filter in the transmission
7)
O O
Replace the spark plug. X X
Lubricate the belt adjuster
1)
X X X X
Lubricate joints and shafts
1)
X X X X
IMPORTANT! When the machine is in operation the hoses are under high pressure. Do not try to connect or disconnect the hoses
when the hydraulic system is operational. This can result in serious personal injuries.