3. Turn the ignition key clockwise to the engine
"ON" position (B) to disengage the ROS.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
schedule. Refer to
Maintenance schedule on
page 17
.
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Do not use tire chains when you operate the
product with a cutting deck..
• Make sure that the cutting deck is level. Refer to
To adjust the parallelism of the cutting deck on
page 24
.
• If the grass is high, start with a high cutting
height and decrease it gradually.
• Move the product forward at low speed if the
grass is high and thick.
• Use full throttle when you cut the grass.
• Cut the grass in an irregular pattern.
• Use the left side of the cutting deck when you
cut near trees, bushes or paths. The blade cuts
approximately 15 mm in from the side of the
cutting deck.
• When you cut large areas, move the product
to the right during 1 or 2 turns around
the work area. This procedure will keep the
grass discharge away from shrubs, fences and
driveways. After approximately 2 turns around
the work area, cut in the opposite direction.
• To get the best cutting result, cut the grass
frequently.
To put the product in freewheel
mode
If it is necessary to move or tow the product without
aid from the engine, you must put the product in
freewheel mode.
WARNING: Do not put the product
in freewheel mode on a slope.
• Push in the freewheel control lever (A) to put the
product in drive mode.
• Pull out the freewheel control lever to put the
product in freewheel mode.
Maintenance
Introduction
WARNING: Read and understand
the safety chapter before you do
maintenance on the product.
16 2301 - 001 - 01.11.2023
To Next Page
Loading...
