• Keep machine free of grass, leaves or other
debris build-up which can touch hot exhaust/
engine parts and burn. Do not allow the mower
deck to plow leaves or other debris which can
cause build-up to occur. Clean any oil or fuel
spillage before operating or storing the machine.
Allow machine to cool before storage.
Safety instructions for operation
Personal protective equipment
WARNING: Read the warning
instructions that follow before you use
the product.
• Use approved personal protective equipment
when you use the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident
does occur. Let your dealer help you select the
right equipment.
• Always wear approved hearing protection. Long
term exposure to noise can result in permanent
hearing impairment.
• Always wear safety glasses or eye protection
while you operate the product or do maintenance
or repairs.
• Always wear protective shoes or protective
boots. Steel toes are recommended. Do not use
the product barefoot.
• Wear gloves when necessary, for example
when you attach, examine or clean the cutting
equipment.
• Do not wear loose-fitting clothing, jewelry or
other items that can get caught in moving parts.
• Do not wear shorts when you operate the
product.
• Keep first aid equipment and fire extinguisher
close at hand.
Safety devices on the product
WARNING:
Read the warning
instructions that follow before you use
the product.
• Do not use a product with safety devices that
are damaged or do not operate correctly. Do a
check of the safety devices regularly. If the safety
devices are damaged, speak to your Husqvarna
service agent.
• Do not make modifications on safety devices. Do
not use the product if protective plates, protective
covers, safety switches or other protective
devices are not attached or are damaged.
To do a check of the operator presence control
(OPC)
WARNING: Do not operate the
product with an operator presence
control (OPC) that does not operate
correctly. If the OPC does not operate
correctly, repair it immediately. Speak to
an approved service agent.
• Make sure that the engine cannot start unless
the brake pedal is pushed down fully and the
cutting deck is disengaged.
• Make sure that the engine stops when the
operator goes away from the seat when the
parking brake is disengaged.
• Make sure that the engine stops when the
operator goes away from the seat when the
cutting deck is engaged.
• Make sure that the clutch control for the cutting
deck cannot operate when the operator is away
from the seat.
To do a check of the reverse operation system
(ROS)
If the reverse operation system does not operate
correctly, repair the product immediately. Speak to
an approved service agent.
1. Start the product. Refer to
To start the product on
page 12
.
2. Engage the cutting deck. Refer to
To engage and
disengage the cutting deck on page 15
.
3. Make sure that the engine stops when you try to
reverse with the ignition key is in the on position
(A).
4. Start the product and engage the cutting deck
again.
5. Turn the ignition switch to the ROS on position
(B).
2285 - 001 - 17.10.2023
7
To Next Page
Loading...
