Husqvarna TS 348XD - SERVICE AND ADJUSTMENTS; MOWER REMOVAL AND INSTALLATION

21
SERVICE AND ADJUSTMENTS
Fig. 25
TO REMOVE MOWER (See Fig. 25)
• Placeattachmentclutchin“DISENGAGED”position.
• Lowerattachmentliftlevertoitslowestposition.
• Removemowerbeltfromelectricclutchpulley(M).See
MowerDriveBeltRemovalin"TOREPLACEMOWER
BLADEDRIVEBELT"inthissection.
• Disconnectfrontlink(E)frommower-removeretainer
spring and washer.
• Go to either side of mower and disconnect mower
suspensionarm(A)fromchassisandrearliftlink(C)
fromrearmowerbracket(D)-removeretainersprings
and washers.
• Gotoothersideofmoweranddisconnectthesuspen-
sion arm and rear lift link.
CAUTION: After rear lift links are discon-
nected, the attachment lift lever will be
spring loaded. Have a tight grip on lift
lever when changing position of the lever.
• Slidemoweroutfromunderrightsideoftractor.
TO INSTALL MOWER (See Fig. 26 - 29)
Ensuretractorisonlevelsurfaceandengageparkingbrake.
• Lowerattachmentliftlevertoitslowestposition.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
NOTE:Ensuremowersidesuspensionarms(A)arepoint-
ing forward before sliding mower under tractor.
• Slide mower under tractor until it is centered under
tractor.
90° END INTEGRATED WASHER END
ANTI-SWAY BAR (S)
TOWARDS TOWARDS
TRANSAXLE MOWER DECK
INSTALLANTI-SWAYBAR(S)(IFEQUIPPED)
Fig. 26
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
• Depressbrakepedalfullyandsetparkingbrake.
• Placeattachmentclutchin“DISENGAGED”position.
• Turnignitionkeyto“STOP”andremovekey.
• Ensurethebladesandallmovingpartshavecompletelystopped.
• Disconnectsparkplugwirefromsparkplugandplacewirewhereitcannotcomeincontactwithplug.
E
A
M
Q
F
B
C
S
O
H
D
D
P