Husqvarna TS 348XD - ATTACHING MOWER LINKS AND ARMS

22
SERVICE AND ADJUSTMENTS
Fig. 31
Fig. 32
• Installbeltontoelectricclutchpulley(M).
Fig. 29
Fig. 30
• ATTACHREARLIFTLINKS(C)-Liftrearcornerof
mower and position slot in link assembly over pin on
rear mower bracket (D)and secure with washer and
retainer spring.
• Repeatonoppositesideoftractor.
• ATTACHFRONTLINK(E)-Workfromleftsideoftrac-
tor.Insertthreadedrodendoflinkassemblythrough
frontholeintractorsuspensionbracket(F).
• Installbushing(O)andlooselyinstallnut(P)andjam
nut(Q).
• Insertflaredendsoflink(E)intoslotsinfrontmower
bracket(H).
• Check Front-To-Back Adjustment in "TO LEVEL
MOWER"inthissection.
E
P
F
Q
H
O
A
B
IMPORTANT: CHECKBELTFORPROPERROUTING
INALLMOWERPULLEYGROOVES.
• Raiseattachmentliftlevertohighestposition.
• Ifnecessary, adjust gaugewheels before operating
mowerasshownintheOperationsectionofthismanual.
SeeMowerDriveBeltInstallationin"TOREPLACEMOWER
BLADEDRIVEBELT"inthissectionofthemanual.
D
C
• Fromrightsideofmower,firstinsert90°endofanti-sway
bar(S)intoholeintransaxlebracket(T),locatednear
leftreartireinfrontoftransaxle.
NOTE:Flashlightmaybehelpful.
NOTE:Dependingonmodel,bracket(T)maybediffer-
ent than shown but hole for anti-sway bar will be in same
position/location.
ANTI-SWAY BAR
(S) LOCATION
TRANSAXLE
BRACKET (T)
LOCATED
BETWEEN REAR
TIRES
PLACE 90° END INTO HOLE
S
T
S. ANTI-SWAY BAR
T. TRANSAXLE BRACKET
Fig. 27
S
D
T
D. RIGHT SIDE
REAR MOWER
BRACKET
S. ANTI-SWAY BAR
T. TRANSAXLE
BRACKET
Fig. 28
• Pivottheintegratedwasherendofanti-swaybar(S)
towards mower deck bracket on right side of mower.
Insertintegratedwasherendofbarintoholeinrear
mowerbracket(D).Movemowerasneededtoinsert
integratedwasherendofbarintorearmowerbracket(D).
• Securewithsmallwasherandsmallretainerspringas
shown.
• ATTACHMOWERSIDESUSPENSIONARMS(A)TO
CHASSIS-Positionholeinarmoverpin(B)onoutside
of tractor chassis and secure with retainer spring.
• Repeatonoppositesideoftractor.
M