Husqvarna TS 348XD - ASSEMBLY PROCEDURES; UNASSEMBLED PARTS AND TOOLS

5
UNASSEMBLED PARTS
ASSEMBLY
Slope Sheet
Key(s)
Keys
(1) Quick
Connect
(1) Oil Drain Tube
Seat
(1) Seat
(3) Flat
Washer
(3) Bolt
Battery
(2) Hex Bolts
(2) Nut Keps
(1) Knob
(1) Cup
Washer
*Installed by Dealer
*Brush Guard Kit
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrenchsizesarelisted.
(1) 5/16"wrench  Utilityknife
(2) 7/16"wrenches  Tirepressuregauge
(2)1/2"wrenches  Pliers
(2) 9/16"wrench
Whenrightorlefthandismentionedinthismanual,itmeans
whenyouareintheoperatingposition(seatedbehindthe
steeringwheel).
Yournewtractorhasbeenassembledatthefactorywithexceptionofthosepartsleftunassembledforshippingpurposes.
Toensuresafeandproperoperationofyourtractorallpartsandhardwareyouassemblemustbetightenedsecurely.Use
the correct tools as necessary to ensure proper tightness.
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Removeallaccessibleloosepartsandpartscartons
from carton.
• Removeendpanelsandlaysidepanelsflat.
• Checkforanyadditionalloosepartsorcartonsand
remove.
BEFORE REMOVING TRACTOR FROM
SKID