24
SERVICE AND ADJUSTMENTS
REPLACING BATTERY (See Fig. 41)
WARNING: Do not short battery ter mi -
nals by allowing a wrench or any other
object to contact both terminals at the
same time. Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc. Positive terminal
must be connected first to prevent
sparking from ac ci den tal grounding.
• Lift hood to raised position.
• Remove terminal cover.
• Disconnect BLACK battery cable then RED battery
cable and carefully remove battery from tractor.
• Install new battery with terminals in same position as
old battery.
• Reinstall terminal cover.
• First connect RED battery cable to positive (+) battery
terminal with bolt and nut as shown. Tighten securely.
• Connect BLACK grounding cable to negative (-) bat tery
terminal with remaining bolt and nut. Tighten securely
• Close hood.
POSITIVE
(RED)
CABLE
TERMINAL
COVER
NEGATIVE
(BLACK)
CABLE
Fig. 41
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 42)
• Raise hood.
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
• To replace, reverse above procedure.
Fig. 42
07002
HEADLIGHT
WIRE
CONNECTOR
HOOD
WEAK OR DEAD
BATTERY
FULLY CHARGED
BATTERY
Fig. 40
TO REMOVE CABLES, REVERSE ORDER -
• BLACK cable first from chassis and then from the fully
charged battery.
• RED cable last from both batteries.
TO REPLACE LED HEADLIGHT
• Raise hood.
• Disconnect harness from LED light.
• Remove mounting screws to remove LED light, reflector
and lens.
• Replace LED light, reflector, or lens as needed.
• Reinstall using mounting screws previously removed.
• Reconnect harness to LED light.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
To Next Page
Loading...
