Husqvarna YTH2748 - Page 43

43
1 532 15 94-60 Wire Asm Inner/Sprg W/plunger
2 532 15 94-71 Shaft Asm Lift RH w/Inf
3 532 10 57-67 Pin Groove
4 812 00 00-02 E Ring #5133-62
5 819 21 16-21 Washer 21/32 x 1 x 21 Ga.
6 532 12 01-83 Bearing Nylon Blk 629 Id
7 532 12 56-31 Grip Handle
8 532 12 45-26 Button Plunger
11 532 17 53-70 Link Lift LH
12 532 17 53-71 Link Lift RH
13 532 12 46-70 Retainer Spring
15 532 17 55-62 Plate Asm. Suspension Front
16 873 35 08-00 Nut Jam Hex 1/2-13 unc
17 532 17 56-89 Trunnion Front Susp.
18 873 80 08-00 Nut Lock w/Wsh 1/2-13 unc
20 532 16 35-52 Retainer Spring
23 532 11 08-07 Nut Special
24 819 13 10-16 Washer 13/32 x 5/8 x 16 Ga.
25 532 16 40-24 Spring
26 532 16 94-84 Retainer Clip
27 532 16 45-43 Rod Adj Lift
28 873 35 06-00 Nut Hex Jam 3/8-16 unc
29 532 13 80-57 Knob Inf 3/8-16 unc Blk W/sym
30 532 15 02-33 Trunnion Infi n Height
31 532 17 62-05 Trunnion Susp. Arm
32 532 17 59-94 Nut Lift Link 7/16-20
36 532 15 50-97 Pointer Height Indicator
37 532 12 39-35 Plug Hole Blk 1.485/1.515 Dia.
38 817 06 05-16 Screw 5/16-18 x 1
40 819 11 24-10 Washer 11/32 x 1-1/2 10 Ga.
41 532 15 50-98 Indicator Height STLT
49 532 14 52-12 Nut Hex Flange Lock
50 532 11 04-52 Nut PUsh Phos & Oil
51 819 17 14-16 Washer 17/32 x 7/8 x 16 Ga.
52 532 17 53-78 Arm Susp. Rear LH
53 532 17 58-02 Arm Susp. Rear RH
54 532 17 55-60 Pin
KEY PART
NO. NO. DESCRIPTION
NOTE: All component dimensions given in U.S. inches
1 inch = 25.4 mm
TRACTOR - MODEL NO. YTH2748 (96013001000), PRODUCT NO. 960 13 00-10
MOWER LIFT