REV A 6-2 606653
1. Clean vehicle, removing trash and dirt accumulation.
2. Check engine oil, brake fluid, transmission fluid, and
coolant levels.
3. Install fully charged battery and attach the battery
cables.
4. Fill fuel tank with fresh fuel.
5. With the park brakes engaged and the gear select lever
in the NEUTRAL position, run the engine at half speed
for 5 minutes. Make sure all warning lights and gauges
are working properly and the readings are normal.
6. Stop the engine and check for oil leaks, loose fittings
and so forth.
7. Tighten any bolts that have loosened and make sure
all hardware is in place.
8. Install all safety shields and review safety precautions
listed in this manual.
9. Check and inflate tires to 18 psi (124 KPa).
10. Check the brakes for proper adjustment. Adjust the
brakes as necessary. Refer to General Service Manual
123604 for more information.
11. Refer to the engine owner’s manual for more informa-
tion.
Always check that fresh oil and coolant have been
added to vehicle. If oil and coolant are drained and
not replaced, engine damage will result.
To Next Page
Loading...
Need help?
General
