To Next PageTo Next Page
Need help?Do you have a question about the Huwil huwilift-verso and is the answer not in the manual?
General| Brand | Huwil |
|---|---|
| Model | huwilift-verso |
| Category | Racks & Stands |
| Language | English |
Follow installation, usage, and regulatory guidelines to ensure safety and prevent injury.
Never open gas springs or damping elements due to high internal tension and risk of injury.
Provides drilling dimensions (V and W) for specified cabinet heights.
Details drilling points and overlay for particle/MDF board flaps.
Specifies drilling points and overlay for 20mm aluminum frame flaps.
Details drilling points and overlay for particle/MDF board flaps.
Specifies drilling points and overlay for 20mm aluminum frame flaps.
Details part numbers for fixation sets for 16mm and 19mm cabinet walls.
The base plate is usable for both left and right carcasse sides.
Connect pre-assembled lid-stay fittings with the transversal stabilisation bar.
Press assembly and snap axis pieces into base for traction lever engagement.
Ensure lifting arm is open before fitting; it is under tension and poses injury risk.
Fit assembly without play and tighten turnbuckle screws (2-4 Nm).
Hang flap with screw 1, leaving slight play for adjustment. Do not fully tighten.
Adjust flap alignment using excenter screw 2. Tighten fixing screw 1 after adjustment.
Adjust flap height using excenter screw. Loosen fixing screws first.
Adjust flap inclination using excenter 2 on base plate when flap is closed.
Adjust final stop (approx. 12 mm) via stop-screw by pulling lifting arm down slightly.
Adjust force for flap weight using allen screw, pulling arm down and following scale.
Verify flap stops in any position from approx. 20 cm opening after correct adjustment.
Choose model by flap height/weight; select bar by cabinet width.
Lists part numbers for huwilift-strato based on flap weight and cabinet dimensions.
Provides part numbers for transversal stabilization bars by cabinet width and length.
