HWM Pegasus 2 - Page 9

9
• An accessory kit for plumbing-in the Pegasus2 system to work with the PRV.
(HWM can supply standard kits containing coloured plastic tubing, a 3-way
manual valve, quick-connect fittings).
• Hanging brackets.
• Cables for sensors (transducers or meters).
• An antenna for communication over the mobile cellular network
(For optional server integration).
• (Optional / If required) External battery.
• A USB Communications cable (an accessory required for on-site installation,
programming, and data retrieval).
The system contains transducers for measurement of water pressure. These may be
built-in (for connection to the system via water pipes) or (where external transducers
employed for direct connection) attached via cables.
Caution: (Pegasus 2 compatibility with Pegasus Plus)
The Pegasus2 system REPLACES previous generations of HWM pressure control
systems, known as Pegasus and Pegasus Plus.
Pegasus2 control box and solenoid box units are not compatible with Pegasus or
Pegasus Plus units; the units cannot be used inter-changeably or mixed.
The Pegasus2 (complete system) can replace a Pegasus or Pegasus Plus (complete
system), depending on the model numbers and settings of the units.
Existing sensors and pipework may be compatible, and may be re-used with a Pegasus2
installation if in good condition.
The cable between the Control Box and Solenoid box is incompatible between old
systems and Pegasus2.
The Pegasus Plus USB Communications cable is also compatible with Pegasus2.