To Next PageTo Next Page
Need help?Do you have a question about the Hydac HDA 5500 SERIES and is the answer not in the manual?
General| Housing Material | Stainless steel |
|---|---|
| Output Signal | 4...20 mA, 0...10 V |
| Accuracy | ±0.5% FS |
| Protection Class | IP65 |
| Media Temperature | -20°C...+100°C |
Details compliance with CE mark and European standards for electromagnetic compatibility and low voltage directives.
Specifies requirements for mounting the HDA 5500 into a control panel, including cut-out dimensions and depth.
Provides guidance on electrical connections, emphasizing EMC standards and interference reduction methods.
Describes the procedure to activate the menu and change the HDA 5500's basic settings.
Presents an overview of the HDA 5500's basic settings menu points, ranges, and default settings.
Details allocation, mode, direction, and delay settings for switching outputs when using the CS 1000.
Illustrates electrical connections between the HDA 5500 and the HLB 1000 sensor.
Shows electrical connections for the HDA 5500 with the CS 1000 sensor and notes conversion requirements.
Lists options for the primary display and provides hints on initialization and range exceedance.
Explains how to view lowest value, peak value, and status signal by using specific keys.
Explains analogue output proportional to input signal and covers 4-20mA and 0-10V output settings.
Defines switch point/hysteresis (SP) and switching window (Win) modes for switching outputs.
Guides on adjusting switch points and hystereses for switching outputs in SP mode.
Guides on adjusting upper and lower switch points for switching outputs in Win mode.
Details how to enable or disable programming for operating settings during normal use.
