Plug the control module into the 120 VAC outlet. #
Plug the sump pump motor into the control module. #
Adjust run time by following Run Time Adjustment steps
on Page 3.#
NOTE: This product defaults to a 10 second run duration
and can be reprogrammed at anytime.#
TEST YOUR INSTALLATION BEFORE LEAVING IT FOR
UNATTENDED USE.#
NOTE: This product will not work if tested in a cup of
water. See How the Sensor Works: Do I need a ground
wire? below for more information.#
• Fill the pit with water until the water level
reaches the tip of the sensor.
• The pump should turn on and the water
level drop.
• When the adjusted runtime is up, the
switch should turn off the pump.
www.hydrocheckproducts.com | customersupport@hydrocheckproducts.com | 1(877)-225-2124
To Next Page
Loading...