68 english
After the first 12
hours of operation
Every 25 hours
of operation
Every 50 hours
of operation
Every 100 hours
of operation
Job to be performed
Rinse cooling system (daily after riding
in salt water)
Check air intake valve
*)
Check rotor wings and damage
(remove)
*)
Check/renew drive dampers
*)
Check throttle cap shaft spring
(replace throttle housing if necessary)
Check steering and switching cables
*)
Replace rubber duckbills that drain the
water from the engine compartment
Check battery clamps
*)
Special skills and tools are required for performing these jobs.
Hydrospace recommends to have these jobs done only by an official Hydrospace dealer.
at least 1x annually
To Next Page
Loading...