.
Extraction
Without lntrusion o2
The elcractor is designed to
give you
the option to enract air by ducting to the oltside
and away
(via
an exterior
wall), orto re-circulate airthrough specially designed
filters to
minimize odours, steam and
condensation.
The choice is
yours
to
decide ai installation, and both systems
are explained in this
booklet.
Werecommendthaiyoureadthis
bookletfromcovertocoverbeforeattemptingto
install
ot opetate the
extractor.
.lnstallation
THIS INSTRUCTION
MUST BE STRICTLY ADHERED
TO. FAILUBE TO COMPLY
COULD BESULT IN OVEBHEATING
AND SERIOUS
DAMAGE TO YOUR APPLI.
ANCE.
Theexlractor is designedtofit
perfectly
betlveen two
units, and to occu
py precisely
one
units
width
(600mm).
When
nsialling
your
extractor above a
heat source, i.e., any
electrical
or
gas
hob, cooker
eic., the fixing height must
l,,/Of BE LESS THAN 65cm
between
the hob and the bottom
oi the extractor.
To secure
the
product
to the wall
you
must initially remove the
grille
/
anti-grease
fllters.
This
is achieved by opening the front
panel
and
pushing
the two calches
(A)
upwards
which willthen
release the
grille.
To Next Page
Loading...