HYGIPLAS J242 / CF912 / CF913 Easytemp Thermometer
Safety Instructions
Clean the probe immediately after each measurement to avoid cross contamination.
Do not expose the appliance to temperatures over 50ºC/122ºF or use in ovens.
Installation
1. Open the battery compartment on the bottom of the appliance.
2. Insert the battery (Negative (-) terminal first).
3. Close the battery cover.
Operation
Temperature Measurement
1. Press the On/Off button to power up the thermometer.
2. Open up the probe to the desired angle.
3. Insert the probe approximately 25mm (1”) into the foodstuff.
4. The temperature of the foodstuff is displayed when the value remains constant.
Units of Measurement
1. Press the ºC/ºF button to alternate between Centigrade and Fahrenheit.
Data Hold
1. Press the HOLD button to keep the current reading displayed.
2. Press the HOLD button again to resume normal operation.