10
OPERATION
1. STARTING & STOPPING (SEE D)
Starting
Move the On/O switch to the “I” or “II” On position.
Stopping
Move the On/O switch to the “0” O position.
WARNING! The tool runs for a few seconds after it has been switched o.
NOTE: Let the motor come to a complete standstill before setting the tool down.
2. USING THE BLOWER (SEE E)
USER TIPS
- Adjusting the Blowing Speed (I or II) according to the desired working condition.
-Hold the blow tube approximately 8” above the ground when operating the tool.
-Use a sweeping motion from side to side. Advance slowly keeping the accumulated debris/leaves in front of
you.
- After blowing the debris/leaves into a pile, it is easy to dispose of the pile.
Caution!
- Do not blow hard objects such as nails, bolts, or rocks.
- Do not operate the blower near bystanders or pets.
- Use extra care when cleaning debris from stairs or other tight areas.
- Wear safety goggles or other suitable eye protection, long pants, and shoes.
3. ADJUSTING THE BLOWING SPEED WITH 2-SPEED SWITCH (SEE F)
CLEANING THE TOOL
Clean the tool regularly.
Warning! Keep your product dry. Under no circumstances spray with water.
- To clean the tool, use only mild soap and a damp cloth.
- Do not use any type of detergent, cleaner or solvent which may contain chemicals that could
seriously damage the plastic.
- Self lubricating bearings are used in your product, therefore lubrication is not required.
To Next Page
Loading...
