HYPERWEAR SandBell - User Guide and Usage; Filling Instructions; Usage Precautions; Resources and Contact

continued on reverse
FILLING INSTRUCTIONS
•
If purchased empty there will be a sticker with filling instructions on one side"
•
A rubber band for closing is located under the sticker"
•
To fill you will need dry, washed “All-Purpose” sand, a small funnel and weight scale "
•
Insert the funnel fully into the fill nozzle and place SandBell on weight scale "
•
Pour in dry sand, shaking SandBell occasionally to allow sand to fill SandBell"
•
Fill to weight indicated on SandBell"
•
Fold fill nozzle in half and tightly wrap rubber band one inch from tip"
•
Insert closed nozzle into SandBell and push off to one side
SandBell®
User Guide
USE
•
Inspect SandBell prior to each use & do not use if you see any damage"
•
Avoid using on any surfaces where a puncture or cut may occur"
•
Do not expose to sharp or pointed objects & avoid striking SandBell with other objects"
•
To grip, grab a handful of sand and neoprene. DO NOT grip by the outer vinyl trim
alone
CONTACT
EMAIL: customerservice@hyperwear.com"
CALL : 1-888-460-0628
RESOURCES
•
Instructional Videos : https://www.youtube.com/hyperwear"
•
Workouts & Articles: https://www.hyperwear.com/blog/"
•
Grip Instructions : https://vimeo.com/album/3695065"
•
Additional Products : https://www.hyperwear.com/shop.html"
© 2016 Hyper Wear Inc. All Rights Reserved. Hyperwear® and SandBell® are registered trademarks of Hyper Wear Inc.