ENGLISH
Overview
A - Charging contacts
B - Proximity sensor
C - Microphone
Charging
It is recommended that the earbuds and charging case be fully charged before rst use.
To charge the earbuds, place them in the charging case and close the lid. If the charging case is not
connected to a power source, the charging case status LED will show which earbuds are charging.
To charge the charging case, connect a power source to the USB-C port on the bottom of the case. The
charging case status LED will ash the current battery level. The LED will then breath to indicate the
charging status until turning solid, indicating a full charge.
Once fully charged, if the charging case’s lid is opened or the button is pushed, the LED will turn o.
Powering on and o the Earbuds
To power on the earbuds, open the charging case. The earbuds will power on and the charging case
status LED will ash to indicate the battery level of the charging case. The earbuds can also be powered
on outside of the case by holding the touch sensors for 3 seconds.
To power o the earbuds, return them to the charging case and close the lid. The earbuds will power o
and the charging case status LED will indicate which earbuds are charging. The earbuds can also be
powered o outside of the case by holding the touch sensors for 8 seconds.
Pairing the Earbuds
1. Power on the earbuds. The earbuds will automatically attempt to reconnect to their last Bluetooth®
enabled device(s).
2. The earbuds will automatically enter pairing mode anytime they are not connected to a Bluetooth®
device. To enter pairing mode while connected to a Bluetooth® device, use the device’s settings to
D - Touch sensor
E - Charging case
F - Charging case button
G - Charging case status LED
H - USB-C port
I - Ear tips (large, small)
J - USB-C to USB-A cable
CHARGING CASE STATUS LED
EARBUDS CHARGING
Yellow Left
Purple Right
Cyan Left & Right
CHARGING CASE STATUS LED
CHARGING CASE BATTERY LEVEL
Solid Green 100 %
Breathing Green 71 % - 99 %
Breathing White 30 % - 70 %
Breathing Red < 30 %
disconnect from the earbuds.
3. On your Bluetooth® enabled device, search for and connect to HyperX Cirro Buds Pro.
4. At this point, an additional Bluetooth® enabled device that had been paired to the earbuds previously
can be reconnected to allow for multipoint connectivity.
Earbud Controls
Left Earbud
Right Earbud
Audio and Noise Control Modes
Charging Case Button
Press the charging case button to check the charging case’s battery level, indicated by ashing the case’s
status LED.
Questions or Setup Issues?
Contact the HyperX support team or see the user manual at hyperx.com/support
WARNING: Permanent hearing damage can occur if a headset is used at high volumes for extended
periods of time.
To Next Page
Loading...
Need help?
General
