To Next PageTo Next Page
Need help?Do you have a question about the Hyster H8.0-12.0XM-6 and is the answer not in the manual?
General| Brand | Hyster |
|---|---|
| Model | H8.0-12.0XM-6 |
| Category | Control Systems |
| Language | English |
Describes the electronic hydraulic control system and its interface program.
Controls movement of lift, lower, tilt, and auxiliary functions.
Discusses temperature and pressure sensors providing analog input.
Used to activate auxiliary functions like Aux2 and Aux3.
Disables functions under specific circumstances.
PWM outputs for proportional functions, nominal range 6-12-18 volts.
ON/OFF signals providing 24 volts when activated.
Prevents engine stalling by reducing hydraulic output.
Protects against extreme hydraulic oil temperatures.
Reduces engine speed to protect pumps from cavitation.
Limits vehicle speed when oil temperature is high.
Adjusts output signals based on load and ramp times.
Limits vehicle speed based on load weight.
Lists parameters configurable via the Hydraulic User Interface Program.
Basic truck configuration settings and access to flow settings.
Defines ramp times for acceleration and deceleration.
Configures default flow and valve settings for pump, mast, carriage.
Enables/disables software-enabled options and standard features.
Adjusts settings for vehicle speed limitation based on load.
Allows setting and adjustment of maximum flows for functions.
Lists core tasks the interface program performs for configuration.
Specifies hardware and software requirements for the program.
Describes the process of downloading and installing the software.
Displays basic system information upon program start-up.
Reminds users to save changed parameters to the controller.
Contains basic truck configuration settings.
Allows defining lever profiles and ramp times for functions.
Sets default flow and valve settings for pump, mast, and carriage.
Enables or disables software features.
Configures vehicle speed limits based on load.
Manages temperature protection settings.
Displays lever/joystick calibration information.
Adjusts maximum flows for hydraulic functions.
Provides input/output info and functional test area.
Overviews actual active errors and their details.
Lists stored error codes and their occurrence times.
Allows saving and loading all controller parameters.
Explains the layout of screens with icons as shortcuts.
Displays actual settings for PVE valve start and end voltages.
Takes the user to the Active Errors Screen when an error number displays.
Step-by-step guide for lever calibration using the software.
Step-by-step guide for joystick calibration using the software.
Lever calibration procedure without using the software.
Joystick calibration procedure without using the software.
