Hytera DIGITAL MOBILE RADIO User Manual

31
Signaling Introduction
Call”) and an appropriate call icon (Private Call: ). ;
Group Call:
). If Auto Reset is enabled (by your dealer),
your radio will enter the Auto Reset mode after successful
encoding, with LED glowing orange, until the Auto Reset Time
expires.
Decoding:
Your radio can automatically decode the 5-Tone signaling when
receiving any matched one.
During decoding, the LED glows green. After successful
decoding, the LCD displays the contact information (or “Five
Tone Call”), an appropriate call icon (Private Call:
;
Group Call:
), and the decoded status message. If Auto
Reset is enabled (by your dealer), your radio will enter the Auto
Reset mode, with LED glowing orange, until the Auto Reset Time
expires.
2-Tone
With this signaling, the radio can transmit and receive 2-Tone
calls.
Encoding:
1. Request your dealer to congure the correct format and type
for the encoding contents.
2. Press PTT key or the programmed One Touch Call 1-One
Touch Call 5 keys to send the 5-Tone signaling.
During encoding, the radio sounds a side tone, the LED glows
red, and the LCD displays the call icon
with contact
information above it. If Auto Reset is enabled (by your dealer),
your radio will enter the Auto Reset mode after successful
encoding, with LED glowing orange, until the Auto Reset Time
expires.
Decoding:
Your radio can automatically decode the 2-Tone signaling when
receiving any matched one.
During decoding, the LED glows green. After successful
decoding, the LCD displays the call icon
and the call
type (selective call, alert call w/voice, alert call) below the icon
according the decoding type.
If Auto Reset is enabled (by your dealer), your radio will enter the
Auto Reset mode, with LED glowing orange, until the Auto Reset
Time expires. The radio cannot enter the Auto Reset mode if it is
an alert call.

Hytera DIGITAL MOBILE RADIO Specifications

General

Brand	Hytera
Model	DIGITAL MOBILE RADIO
Category	Radio
Language	English