Hytera MD78X - Page 450

Troubleshooting Flow Chart
VHF (136MHz
–
174MHz)
34
Check FGU
U915 outputs 5 V and
U918 outputs 3.3 V?
Replace U915 or
U918
No
Q104 outputs 4.3 V?
Yes
Check Q104
No
Yes
VCO oscillates?[1]
Q108, Q112, Q101, and
Q105 work normally?
[2]
No
Replace Q106,
Q110,
Q100, and Q103
Yes
Check D107, D108, D109, D110,
D121, D122, D125, and D126
No
TP124 CV is normal?[4]
Yes
PLL U100 is normal?
[5]
Yes
No
Replace PLL U100
No
Check U101, U102,
R187, and R171
TP109 feedback is
normal?[6]
Yes
Yes
Check the feedback
circuit
Check CPU data circuit
Yes
No
End
Q106, Q110, Q100, and
Q103 work normally?
[3]
No
Replace Q108,
Q112,
Q101, and Q105
Oscillates (19.2 MHz)?[7]
Yes
Check 19.2MHz
oscillator circuit
No
Description of normal situations:
[1] The oscillation frequency of RX TP123 and TX TP111 can be detected.
[2] Q108, Q112, Q101, and Q105 are turned on and output about 4.3 V.
[3] The difference between the emitter voltage and base voltage as for Q106, Q110, Q100 and Q103 is
about 0.7 V.
[4] The CV of TP124 ranges from 0.5 V to 4.5 V.
[5] PLL U100 is supplied by 5 V and 3.3 V normally.
[6] The power from TP109 to PLL is about -13 dBm.
[7] TP100 outputs 19.2 MHz signal.