Hytera PNC380 - PoC Service; Initiating a PoC Call

User Manual
PoC Service
12
3. PoC Service
The Push-to-Talk over Cellular (PoC) service provides one-to-one and one-to-many voice communications over
the wider-coverage public network.
This service is available only when you have installed the PoC application on the radio.
After the radio is connected to a WLAN or cellular network, you can initiate a call through the PoC application.
1. Press the Navigation key to select the PoC application, and then press the OK/Menu key.
2. Do either of the following:
 Select a contact from the contact list or recent call list.
 Enter a contact number in the dialpad.
3. Press the Option key to select a call type, and then press the OK/Menu key.
4. Speak into the microphone.
 For a half-duplex voice call, press and hold the PTT key to speak, and release the PTT key after
finishing speaking.
 For a full-duplex voice call, speak directly without pressing the PTT key.
If you set the standby group, you can initiate a call to the group directly.
1. Press the Navigation key to select the PoC application, and then press the OK/Menu key.
2. Press and hold the PTT key to speak, and release the PTT key after finishing speaking.
For more operations, refer to the User Manual of the PoC application.