34
This option allows you to calibrate the time currently displayed on your terminal with GPS
time, and is correlative to the Time Zone option.
¾ Data Transmit
You may choose to transmit GPS data to an individual user, a group of users, or the
control center. This option is correlative to the Send Mode option.
Operations to send GPS data are similar to that of short message. Received GPS data
are saved in “Message->Inbox”.
Individual
To transmit GPS data to an individual user.
Group
To transmit GPS data to all users included in a certain group.
Note: To implement the Data Transmit function, the terminal must operate in TMO
mode. And GPS data is deemed valid only when the GPS receiver has received data from
at least 3 satellites.
Otherwise, “GPS data invalid” will appear on the screen when you attempt to transmit
GPS data.
¾ GPS Setup
You may set the time zone and select a method to transmit GPS data.
Time Zone
You may select a time zone according to terminal location or your preference. There are
25 available time zones, used for time calibration.
Send Mode
You may choose whether to send GPS data to a specified target periodically. The
transmission interval is programmable by your dealer. There are two transmission modes
available:
z Manual Send
To manually transmit GPS data to other terminals.
z Auto Send
To periodically transmit GPS data to other terminals.
To Next Page
Loading...
