3. Loosen the screw at the back of the top cover, and then pull the top cover to remove it.
4. Loosen the 6 screws locking the PA heat sink, remove all power, data and RF cables from the PA,
and finally remove the PA heat sink. See the figure below.
5. Connect the RF cable. See the figure below.
6. Install the duplexer to the repeater.
After the duplexer is mounted properly, fasten it with the 2 screws inside the housing and on the side
respectively.
7. Then attach the PA heat sink and connect all cables.
8. Close the repeater cover.
Installation Diagram
To Next Page
Loading...
