Hytera RD98X series - Repeater Configuration

Hytera DMR System Planner
113
3.4.3 Repeater Configuration
To get normal communications, you can configure following parameters via RDAC to
set the repeater in good performance.
Basic setting:
 Powering on
Designated power-up zone/channel
Designate power-on channel
Designate power-on zone
 Audio Priority
You can select one of the following priorities:
FCFS
Path Priority
Local PTT Priority
 Microphone
Set the value of the internal microphone gain.
Set the value of the external microphone gain.
 IP Multi-site Connect
Set the jitter buffer length
Set beacon duration
Set beacon interval
Set repeat request priority
Set access manager
Set start ID/end ID
Set CDCSS encoding and decoding frequency value