10
Assembly and Disassembly
Attaching/Removing the Battery
Attaching the Battery
1. Slightly press the belt clip, and insert the tab at the top of the battery into
the slots at the top of the radio’s body, as shown in gure 1.
Note: Make sure the battery tab is fully inserted into the radio's
slot.
2. Slightly press the bottom of the battery until a click is heard. By then, the
battery latch locks with the main unit and assembly is nished. See gure 2
below.
Note: If the battery is loose or unsecured, please take it down and
attach it again.
Removing the Battery
1. Please turn off the radio rst. Then hold the top of radio unit and press the
belt clip to make its bottom up. Lift the battery latch, as shown in gure 3.
2. When the bottom of battery is lifted, release the battery latch and remove
the battery from the radio’s body, as shown in gure 4.
Note: To avoid serious abrasion between the top tap and the slot,
do not tilt the battery to a large angle.
Figure 1 Figure 2
Figure 3 Figure 4
To Next Page
Loading...
