Owner’s Manual
Before Use
7
4. Before Use
4.1 Installation
4.1.1
Installation Instructions
z This terminal is designed for a 10.8–15.6V (typical: 13.2V) negative ground electrical system. Please
check the ground polarity and voltage of the vehicle power supply before you install this terminal.
z Plan a proper position to ensure sufficient space for heat dissipation, thus avoiding unexpected
damage to other equipments in the vehicle due to overheating of the terminal that operates under
high current.
z It is suggested to route the antennas and power cords in a concealed way, so that the driver can
access the controls and operate easily.
4.1.2 Installation Tools
Item Qty.
Digital multimeter 1
Slotted screwdriver 1
Philips screwdriver 1
Torx screwdriver 1
Adjustable wrench 1
Hex socket sleeve kit 1
Electric iron (40W) 1
Electric drill (better with battery) 1
Needle nose pliers 1
Diagonal pliers 1
Cable tie several
Insulation tape several
To Next Page
Loading...
