Hytera TETRA MT680 - Message Handling; Status Messages; User Messages

Message
Owner’s Manual
22
9. Message
9.1 Status Message
Status message, which should be programmed by your dealer only, can facilitate instant messaging of
the frequently-used messages. You can only send or view rather than editing the status messages.
When the message is sent successfully, the target terminal will receive either the status ID of the status
message (if the message text has not been predefined via CPS) or the predefined text (if the message
text has been predefined via CPS).
Sending a Status Message
z Press the Function/P1 key or OK key and navigate to “Message -> Create Msg -> StatusMsg -> Sel
Msg”. Select a desired status message, and press the OK key to proceed. Choose either an
individual or a group as the target contact, input the appropriate number and press OK to complete.
Long press the programmed Send StatusMsg key to send the preset status message directly. 
View the Status Message
When the icon appears in the status bar, it indicates there is/are unread message(s). Do as follows
to view it:
z In the prompt screen for an unread message, press the OK key to enter the Inbox, and press OK key
again to read.
z In the home screen, press the Function/P1 key or OK key and navigate to “Message -> Inbox ”.
Then you can view the unread message.
9.2 User Message
9.2.1
TMO
Editing a User Message
Press the Function/P1 key or OK key and navigate to “Message -> Create Msg -> User Msg”. Press OK
again to edit a user message.
Sending a User Message
After editing, press OK to confirm. Then select the target contact and decide whether to send it as a flash
message.