10
This step allows to specify the Wi-Fi network name (SSID) and
password by performing the following actions (refer to Figure 5)
1. Enter the name to be assigned to the network (SSID)
2. Enter the password
3. Retype the password
When all the required information has been specified, the button
Next becomes active, allowing to proceed to Wizard Step 6.
If the Skip button is pressed, no changes will be made to the cur-
rent values of SSID and password, displayed on the screen.
The configuration can be completed later on from the Wi-Fi con-
figuration page (Section 3.3) or by restarting the Wizard from
the Menu in the Home page (see Section 4.6).
The Back button can be clicked to return to the previous Step.
Figure 5. First Configuration Wizard – Wi-Fi Access Point
NOTE:
If the Wizard is run at first device switch-on or after a reset to
device factory configuration, the SSID and password will be
preset to their default values, which are printed on a label or
encoded in the QR-Code on the device itself.
After the modification of Wi-Fi parameters in the Wizard, it
will not be possible to use information printed on label or
QR-Code.
Step 5 – Wi-Fi Network Configuration
To Next Page
Loading...
Need help?
General