Register for remote monitoring
●
When the product is registered in the remote monitoring, the following restrictions will
be applied.
・
Only “1-screen live sequence” and “Switch by alarm terminal input” are available for
operation mode of the sub monitor.
・
The signal format of HDMI output will be fixed to 1080p.
・
No thumbnail will be displayed on the timeline of the main monitor.
* Time (seconds) differs depending on the refresh interval setting of the camera (0.2 - 5
seconds). In the recorder, the refresh interval setting of the camera is set to 1 second at
the camera registration.
Refer to the operating instructions of the camera for information about the refresh
interval setting.
Before using this product
Motion detection ( VMD) function
The motion detection (VMD) function of cameras detects motions referring to changes of
luminance (brightness) in areas set in advance.
The motion detection function will not effectively work in the following situations or may
sometimes be malfunctioning.
●
When there is a very little difference in luminance (brightness) between a background
and a subject
●
When brightness of images is low such as at night
●
When a subject moves very slow
●
When a subject is very small
●
When the amount of rays of light incidence changes frequently such as at a window or
outdoors.
●
When light such as sunlight or car headlight comes from outside
●
When a fluorescent lamp flickers
●
When a subject has depth
When configuring the motion detection settings, check the function performance both in
Preface
7
To Next Page
Loading...
Need help?
General
