Need help?Do you have a question about the I-Sotec i-soamp-2 and is the answer not in the manual?
Explains how the i-soamp-2 connects to the vehicle's cable harness and original radio using an adaptor, referencing online resources.
Emphasizes using only original i-sotec subwoofers to prevent damage to the i-soamp-2 amplifier due to increased power requirements.
Crucial safety instruction to disconnect the car battery before connecting the i-soamp-2 to the 12V electrical system.
Guidance on routing the power connector cable safely within the vehicle, avoiding kinks and sharp metal parts, using grommets if necessary.
Explains the function of the black (ground) and red (+12V) cables in the power connector cable for proper battery connection.
Stipulates using only 20A fuses for replacement to prevent device damage and potential dangers from higher values.
Mandates inserting a main fuse in the positive cable within 12 inches (30 cm) of the battery post for fire prevention in case of cable damage.
Troubleshooting steps for when the green power indicator is off, checking fuses, radio status, and cable connections.
Explains that the red 'Temp' indicator signifies overheating of the amplifier.
Explains that the yellow 'Low batt.' indicator signifies the battery voltage has fallen below 10.4V.
Lists potential causes for distorted sound, including short circuits, faulty speakers, high volume, and improper radio tone settings.
Addresses causes of background noise, such as poor ground connections, multiple grounding points, and signal cable interference.
General| Brand | I-Sotec |
|---|---|
| Model | i-soamp-2 |
| Category | Car Amplifier |
| Language | English |
To Next Page
