To Next PageTo Next Page
Need help?Do you have a question about the I.VA.CO. SC Series and is the answer not in the manual?
Purpose of the manual to ease installation, operation, and maintenance of SC side channel blowers.
Inspect and check goods against shipping documents to ensure no damages occurred during transportation.
Details warranty period, coverage for defects, and exclusions like wearing parts or misuse.
Activate all protection devices before start-up to avoid hazardous risks during operation and maintenance.
Highlights dangers from suction, discharge, high temperatures, rotating parts, and other operational hazards.
Transport by adequate equipment, following safety standards, using serviceable lifting slings operated by skillful personnel.
Handle packing with care, avoid shocks, heavy loads, and store in a dry, protected, clean area.
Explains the regenerative downflow theory and how the radial blade impeller works in the toroidal chamber.
Machines are made of aluminum alloy, life-pre-lubricated bearings, and comply with various EC directives.
Details available accessories like filters, hoses, valves, gauges, and acoustic enclosures.
Used to convey air/gas in non-explosive environments; prohibited uses include explosive fluids or liquids.
Install in an aerated place, within specified temperature and humidity limits, and provide outdoor protection.
Equipped with silencers; avoid installing on noise-conducting parts to minimize noise propagation.
Use flexible connectors, avoid rigid connections, ensure proper pipe sizing, and remove sealing plugs before connection.
Must be done by trained personnel; check voltage, frequency, phase match, and ensure proper earthing.
Illustrates electrical connection diagrams for three-phase and single-phase motors.
Provides diagrams for the correct installation of various accessories.
Ensure compliance with use, values, prohibition considerations, and safety checks before powering up.
Machines self-adjust to differential pressure; avoid throttling flow, use relief valves instead.
Machines require minimal maintenance; bearing life is 12,000 hours. Periodic checks by qualified personnel are essential.
Clean external parts, ventilation grids, and filter cartridges regularly to prevent overheating and performance loss.
Replace sealing rings and bearings when worn (max 2 years) to prevent fluid losses or excessive noise.
Table listing malfunctions, possible causes, and remedies for motor issues, pressure loss, noise, and leaks.
Procedure for long shut downs: disconnect power, close lines, release pressure, and use sealing plugs.
Apply specific disposal procedures, clean internals from hazardous fluids, and comply with local laws.
Disassembly and assembly must be by trained personnel. Return machine to I.VA.CO. SRL for recommended repair.
Mandatory information for ordering: part description, item number, model, and lot number.
General