EasyManua.ls Logo

iBall Nirantar UPS-621V - Important Safety Instructions; Troubleshooting Common Issues; Technical Specifications

iBall Nirantar UPS-621V
2 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IMPORTANT SAFETY INSTRUCTION
To safely operate this uninterruptible power supply system, please read and follow all
instructions carefully. Please read this manual thoroughly before attempting to unpack, install,
or operate UPS, and keep this manual for further reference.
This UPS utilizes voltages that may be hazardous. Do not attempt to disassemble the
unit. The unit contains no user replaceable parts. Only authorized service personnel
may perform repairs.
Internal battery voltage is 12V DC. Sealed, lead-acid, 6 cells battery.
Connection to any other type of receptacle other than a two-pole, three-wire grounded
receptacle may result in shock hazard as well as violate local electrical codes.
In the event of an emergency, press the OFF button and disconnect the power cord
from the AC power supply to properly disable the UPS.
DO NOT allow liquids or any foreign object to enter the UPS. Do not place beverages
or any other liquid-containing vessels on or near the unit.
This unit intended for installation in a controlled environment (temperature controlled,
indoor area free of conductive contaminants). Avoid installing the UPS in location
where there is standing or running water, or excessive humidity.
DO NOT plug the UPS input into its own output.
DO NOT attach a power strip or surge suppressor to the UPS.
DO NOT attach non-computer-related items, such as medical equipment, life-support
equipment, microwave ovens, or vacuum cleaners to UPS
To reduce the risk of overheating the UPS, do not cover the UPS cooling vents and
avoid exposing the unit to direct sunlight or installing the unit near heat emitting
appliances such as space heaters or furnaces.
Unplug the UPS prior to cleaning and do not use liquid or spray detergent.
DO NOT dispose of batteries in a fire as they may explode.
DO NOT open or destroy the battery or batteries. Released electrolyte is harmful to
the skin and eyes. It may be toxic.
Servicing of batteries should be performed or supervised by personnel
knowledgeable of batteries and the required precautions should be taken. Keep
unauthorized personnel away from batteries.
When replacing batteries, replace with the same number of the sealed lead-acid
batteries.
The batteries already installed by the supplier are operator installable and may be
operated by laymen.
The main socket outlet that supplier the UPS shall be installed near the UPS and shall
be easily accessible.
For any technical help on iBall products, please contact support@iball.co.in
*Product specifications are subject to change without notice. ** Battery backup may vary
depending on the configuration of computer system & other devices used. * All trademarks,
logos, brands & product names are properties of their respective owners. * Warranty: All
iBall products are governed by iBall warranty terms. Refer www.iBall.co.in
TROUBLE SHOOTING
Use the table below to solve minor problems.
Problem
Possible Cause
No LED display on the front panel.
1. Battery weak
2. Battery defect.
3. Power switch is not pressed.
Alarm buzzer beeps continuously
when AC supply is normal.
Overload of the UPS.
When power failure, backup time is
shorten.
1. Overload of the UPS.
2. Battery voltage is too low.
3. Battery defect due to high temperature
operation environment, or improper
operation to battery.
Mains normal but Green LED is
flashing.
1. Fuse is blown.
2. Power cord is loose
3. Battery defect.
If any abnormal situations occur that are not listed above, please call service people immediately.
SPECIFICATION
CAPACITY
VA/W
600VA / 360W
INPUT
Voltage
230V AC
Voltage Range
140-300V AC
Frequency
4565Hz
OUTPUT
Voltage
230V AC
Voltage Regulation (Battery Mode)
195-253V
Frequency
50Hz or 60Hz
Frequency Regulation (Battery Mode)
+ / - 1 Hz
Output Waveform
Modified Sine wave
BATTERY
Battery Type
12V, 7AH
Recharge Time
6 hours to charge 90% after complete discharge
TRANSFER TIME
Typical
4-8ms
INDICATOR
AC Mode
Green light
Backup Mode
Green light flashing
AUDIBLE ALARM
Backup Mode
Beeping every 10 seconds
Low Battery
Beeping every second
Overload
Beeping every 0.5 seconds
Fault
Continuously Beeping
PROTECTION
Full Protection
Discharge, overcharge, and overload protection
PHYSICAL
Outlet
3-Pin x 3
Dimension(mm),DxWxH
279 x 101 x 142 mm
Net Weight
4.2 kgs
ENVIRONMENT
Operating Environment
C - 40ºC, 0-90 % RH (non-condensing)
Noise Level
Less than 40dB