4. Reconnect the ac power cables (dc power cables in a dc-powered system) to the
CEC drawer.
5. Turn on the power.
Is the error code 1011 1C0x displayed?
NO Go to “Step 1524-8”.
YES The last card you installed is defective. Replace the last card you
installed.This ends the procedure. Go to ″MAP 410: Repair Checkout″ in the
RS/6000 and
Eserver
pSeries Diagnostics Information for Multiple Bus
Systems
.
Step 1524-8
Have all the cards that were removed in “Step 1524-7” on page 111 been
reinstalled?
NO Go to “Step 1524-7” on page 111 and reinstall the next card in the list.
YES Replace the CEC backplane, location: U1.1-P1.
This ends the procedure. Go to ″MAP 410: Repair Checkout″ in the
RS/6000
and
Eserver
pSeries Diagnostics Information for Multiple Bus Systems
.
112 Service Guide
To Next Page
Loading...