Chapter 5. Multiaccess Enclosure Firmware and Operational
Code
This chapter explains how:
To access to multiaccess enclosure and use the firmware or the operational
code for running diagnostics.
To access to multiaccess enclosure and use the firmware for configuration,
boot sequence, or utilities.
Running Diagnostics
There are two ways to run diagnostic on the multiaccess enclosure depending the
multiaccess enclosure status.
Select in the following table what you intend to do:
What you want to do Go to
Run diagnostics on the complete
multiaccess enclosure after installation
(multiaccess enclosure not configured and
without operational code).
“Accessing the Firmware from the Service
Processor” on page 5-3
Run diagnostics on part of the
multiaccess enclosure which is
operational (multiaccess enclosure
configured and operational code loaded).
“Accessing the Operational Diagnostics
from the Service Processor” on
page 5-42
Copyright IBM Corp. 1998, 1999 5-1
To Next Page
Loading...
