Installing Options
If the AC Indicator LED is OFF, refer to Chapter 3, “Multiaccess Enclosure
Problem Determination” on page 3-1.
10. Switch ON the power module.
11. Verify that the DC Indicator LED is ON and the Overcurrent Indicator
LED is OFF.
If the AC Indicator LED is OFF or the Overcurrent Indicator LED is ON,
refer to Chapter 3, “Multiaccess Enclosure Problem Determination” on
page 3-1.
12. Close the front and back doors of the Controller Expansion
13. Notify the Customer that you are finished installing the feature.
Test procedures.
No test required.
Field Updating.
None.
Go to “After Installation.” on page 6-17 .
Chapter 6. Installing Options 6-5
To Next Page