IBM 900 - Page 25

About this Book
Who Should Use this Book
The IBM personnel using this book should be:
 Trained to service the multiaccess enclosure, 3746-900, and 3746-950.
 Familiar with the configuration of the 3746-900, and 3746-950.
 Familiar with the multiaccess enclosure service documentation.
How to Use this Book
This book provides procedures for installing and maintaining an multiaccess
enclosure, starting from EC F12720. To ensure the most efficient installation:
 Read the instructions carefully before attempting to do them,
 Complete each step before going to the next one,
 Go through the chapters sequentially.
How this Book is Organized
Chapter 1 Presents the procedures to install and connect the multiaccess
enclosure. It also gives procedures to customize the multiaccess
enclosure parameters.
Chapter 2 Presents the software maintenance procedures for the multiaccess
enclosure.
Chapter 3 Gives the procedures for problem determination.
Chapter 4 Gives the procedures for FRU exchange.
Chapter 5 Gives the procedures to access firmware and operational code
Chapter 6 Gives the procedures for adding or removing options.
Chapter 7 Gives the procedures for relocating or removing the multiaccess
enclosure.
Appendix A Gives the component locations of the multiaccess enclosure
Appendix B Gives the adapter plugging rules.
Appendix C Provides parameter worksheet for multiaccess enclosure.
Appendix D Gives the component locations for units installed in a controller
expansion.
Appendix E Gives how to manage the operational code and configuration files.
Appendix F Gives the common tasks.
 Copyright IBM Corp. 1998, 1999 xxiii