IBM IC25N020ATDA04 - Travelstar 20 GB Hard Drive - Figure 86. Identify Device Information (5 of 7)

Current Master Password Revision CodesXXXXH92
Current Advanced Power Management level
15- 8(=40h) Reserved
7- 0(=xxh) Correct Advanced Power Management level
set by Set Features Command (01h to FEh)
40XXH91
Time required for Enhance security erase completion
0000 : Not supported
0000H90
Time required for security erase unit completion
Time = value (XXXXh)*2 [minutes]
XXXXH89
Ultra DMA Transfer mode (mode 5 supported)
15-14(=0) Reserved
13(=x) 1=UltraDMA mode 5 is selected
12(=X) 1=UltraDMA mode 4 is selected
11(=X) 1=UltraDMA mode 3 is selected
10(=X) 1=UltraDMA mode 2 is selected
9(=X) 1=UltraDMA mode 1 is selected
8(=X) 1=UltraDMA mode 0 is selected
7-5(=0) Reserved
4(=1) 1=UltraDMA mode 4 is supported
3(=1) 1=UltraDMA mode 3 is supported
2(=1) 1=UltraDMA mode 2 is supported
1(=1) 1=UltraDMA mode 1 is supported
0(=1) 1=UltraDMA mode 0 is supported
XX3FH88
Command set/feature enabled
15(=0) Always
14(=1) Always
13- 2(=0) Reserved
1(=x) 1=SMART self-test supported
0(=x) 1=SMART error logging supported
4000H87
Command set/feature enabled
15-12(=0) Reserved
11(=x) 1=Device Configuration Overlay supported
10-9(=0) 1=Reserved
8(=1) 1=Device Configuration Overlay supported
7(=X) 1=Address Offset mode enabled
6(=0) 1=SET FEATURES subcommand required to spin-up
5(=0) 1=Power-Up In Standby feature set has been
enabled via the SET FEATURES command
4(=0) 1=Removable Media Status Notification Feature
Set enabled
3(=X) 1=Advanced Power management Feature Set enabled
2(=0) 1=CFA Feature Set supported
1(=0) 1=READ/WRITE DMA QUEUED command supported
0(=0) 1=DOWNLOAD MICROCODE command supported
*
*
*
0XXXH86
DescriptionContentWord
Figure 86. Identify device information (5 of 7)
Note. The ' *' mark in the 'Content' field indicates the use of those parameters that are vendor specific.
)
Travelstar 48GH, 30GN & 15GN hard disk drive specifications
130