13.33.2.9 Error logging capability
If bit = 1, the device supports the Error Logging
The Error Logging support bit
13.33.2.10 Self-test failure check point
This byte indicates the section of self-test where the device detected a failure.
13.33.2.11 Self-test completion time
These bytes are the minimum time in minutes to complete the self-test.
13.33.2.12 Data Structure Checksum
The Data Structure Checksum is the 2's compliment of the result of a simple 8-bit addition of the first 511
bytes in the data structure.
13.33.3 Device Attribute Thresholds data structure
The following defines the 512 bytes that make up the Attribute Threshold information. This data structure
is accessed by the host in its entirety using the S.M.A.R.T. Read Attribute Thresholds. All multibyte fields
shown in these data structures follow the ATA/ATAPI-5 specification for byte ordering. This means that
the least significant byte occupies the lowest numbered byte address location in the field.
The sequence of active Attribute Thresholds will appear in the same order as their corresponding
Attribute Values.
Data Structure Revision Number
Figure 121. Device Attribute Thresholds Data Structure
(*1) - See the following definitions
(*2) - Value varied by actual operating condition
(*3) - Filled with 00h
13.33.3.1 Data Structure revision number
This value is the same as the value used in the Device Attributes Values Data Structure.
Travelstar 48GH, 30GN & 15GN hard disk drive specifications
179
To Next Page
Loading...
