Figure 30. Mounting hole locations for the 48 GB model
6.5.3 Connector and jumper description
A jumper is used to designate the drive address as either master or slave. The jumper setting method is
described in Section 7.10, "Drive Address Setting" on page 62.
Connector specifications are included in Section 7.0, "Electrical interface specifications" beginning on
page 45.
6.5.4 Mounting orientation
The drive will operate in all axes (6 directions) and will stay within the specified error rates when tilted
±5 degrees from these positions.
Performance and error rate will stay within specification limits if the drive is operated in the other
permissible orientations from which it was formatted. Thus a drive formatted in a horizontal orientation will
be able to run vertically and vice versa.
The recommended mounting screw torque is 3.0±0.5 kgf-cm.
The recommended mounting screw depth is 3.0±0.3 mm for bottom and 3.5±0.5 mm for horizontal
mounting.
Travelstar 48GH, 30GN & 15GN hard disk drive specifications
35
To Next Page
Loading...
