13.4 Execute Device Diagnostic (90h)
see belowStatus1 0 0 1 0 0 0 0Command
- - - - - - - -Device/Head1 - 1 - - - - -Device/Head
- - - - - - - -Cylinder High- - - - - - - -Cylinder High
- - - - - - - -Cylinder Low- - - - - - - -Cylinder Low
- - - - - - - -Sector Number- - - - - - - -Sector Number
- - - - - - - -Sector Count- - - - - - - -Sector Count
see belowError- - - - - - - -Feature
- - - - - - - -Data
- - - - - - - -
Data
7 6 5 4 3 2 1 0Register7 6 5 4 3 2 1 0Register
Command Block Input RegistersCommand Block Output Registers
0-0--000VVVVVVV0
ERRIDXCORDRQDSCDFRDYBSYAMNT0NABT0IDN0UNCCRC
0123456701234567
Status RegisterError Register
Figure 81. Execute Device Diagnostic command (90h)
The Execute Device Diagnostic command performs the internal diagnostic tests implemented by the
device. The results of the test are stored in the Error Register.
The normal Error Register bit definitions do not apply to this command. Instead, the register contains a
diagnostic code. See Figure 59 on page 75 for the definition.
Travelstar 60GH & 40GN hard disk drive specifications
117