13.12 Read Buffer (E4h)
see belowStatus1 1 1 0 0 1 0 0Command
- - - - - - - -Device/Head1 - 1 D - - - -Device/Head
- - - - - - - -Cylinder High- - - - - - - -Cylinder High
- - - - - - - -Cylinder Low- - - - - - - -Cylinder Low
- - - - - - - -Sector Number- - - - - - - -Sector Number
- - - - - - - -Sector Count- - - - - - - -Sector Count
see belowError- - - - - - - -Feature
- - - - - - - -Data- - - - - - - -Data
7 6 5 4 3 2 1 0Register7 6 5 4 3 2 1 0Register
Command Block Input RegistersCommand Block Output Registers
V-0--0V000V00000
ERRIDXCORDRQDSCDFRDYBSYAMNT0NABT0IDN0UNCCRC
0123456701234567
Status RegisterError Register
Figure 97. Read Buffer command (E4h)
The Read Buffer command transfers a sector of data from the sector buffer of the device to the host.
The sector is transferred through the Data Register 16 bits at a time.
The sector transferred will be from the same part of the buffer written to by the last Write Buffer command.
The contents of the sector may be different if any reads or writes have occurred since the Write Buffer
command was issued.
Travelstar 60GH & 40GN hard disk drive specifications
134
To Next Page
Loading...
