13.34 Standby Immediate (E0h/94h)
see belowStatus1 1 1 0 0 0 0 0Command
- - - - - - - -Device/Head1 - 1 D - - - -Device/Head
- - - - - - - -Cylinder High- - - - - - - -Cylinder High
- - - - - - - -Cylinder Low- - - - - - - -Cylinder Low
- - - - - - - -Sector Number- - - - - - - -Sector Number
- - - - - - - -Sector Count- - - - - - - -Sector Count
see belowError- - - - - - - -Feature
- - - - - - - -Data- - - - - - - -Data
7 6 5 4 3 2 1 0Register7 6 5 4 3 2 1 0Register
Command Block Input RegistersCommand Block Output Registers
V-0-V0V000V00000
ERRIDXCORDRQDSCDFRDYBSYAMNT0NABT0IDN0UNCCRC
0123456701234567
Status RegisterError Register
Figure 135. Standby Immediate command (E0h/94h)
The Standby Immediate command causes the device to enter the Standby mode immediately.
When this command is issued, the device confirms the completion of the cached write commands before it
asserts the INTRQ. Following the INTRQ the interface remains active and the device is spun down. If the
device is already spun down, the spin down sequence is not executed.
During the Standby mode the device will respond to commands, however there will be a delay while wait-
ing for the spindle to reach operating speed.
The Standby Immediate command will not affect the auto power down time-out parameter.
Travelstar 60GH & 40GN hard disk drive specifications
183
To Next Page
Loading...
