IBM IC35L020 - Deskstar 20 GB Hard Drive - Figure 112. Set Max Set Password; Figure 113. Set Max Set Password Data Contents; Set Max Set Password (Feature = 01 H)

15.29.1 Set Max Set Password (Feature = 01h)
see belowStatus1 1 1 1 1 0 0 1Command
1 – 1 D – – – –Device/Head1 – 1 D – – – –Device/Head
– – – – – – – –Cylinder High– – – – – – – –Cylinder High
– – – – – – – –Cylinder Low– – – – – – – –Cylinder Low
– – – – – – – –Sector Number– – – – – – – –Sector Number
– – – – – – – –Sector Count– – – – – – – –Sector Count
see belowError0 0 0 0 0 0 0 1Feature
– – – – – – – –Data– – – – – – – –Data
7 6 5 4 3 2 1 0Register7 6 5 4 3 2 1 0Register
Command Block Input RegistersCommand Block Output Registers
V–0––0V000V00000
ER
R
IDXCORDRQDSCDFRDYBSYAMNT0NABT0IDN0UNCCRC
0123456701234567
Status RegisterError Register
Figure 112. Set Max Set Password
The device regards as Set Max Address command if this command is immediately preceded by a Read
Native Max Address command.
This command requests a transfer of a single sector of data from the host including the information
specified in the following figure.
The password is retained by the device until the next power cycle. When the device accepts this
command, the device is in Set Max Unlocked state.
Reserved
Password (32 byte)
Reserved
00
01–16
17–255
DescriptionWord
Figure 113. Set Max Set Password data contents
Deskstar 60 GXP Hard disk drive specification
153