To Next Page

To Previous Page

QUICK SETUP Submenus

117

Maximum Label Length range is dependent on the Label Width value

selected, printhead installed (203 or 300 DPI). See Appendix A for

specifications.

NOTE: See “Set Label Length” on page 141.

Label Width

This option specifies the physical width of the image to be printed. The value

can be specified in inches or millimeters depending on the setting of the Units

submenu under the MEDIA CONTROL menu. The allowable range in inches

is 00.1 to the maximum print width of the printer. The allowable range in

millimeters is 2.5 to the maximum width of the printer.

Ver Image Shift

This option specifies the amount to shift an image vertically up (-) or down (+)

for precise positioning on the label. The actual height of the image is not

affected by this parameter. The allowable range is -1.00 inches to the current

Label Length value setting, up to a maximum of 12.80 inches, in .01 inch

increments.

The factory default value is 0.00 inches.

Hor Image Shift

This option specifies the amount to shift an image horizontally left (-) or right

(+) for precise positioning on the label. The actual width of the image is not

affected by this parameter. The allowable range is -1.00 to +1.00 inches in .01

inch increments.

The factory default value is 0.00 inches.

Orientation

This menu item selects the image orientation to be used when printing the

label.

• Portrait. Portrait refers to vertical page orientation, where the height of a

page is greater than its width. The top edge of the image is parallel to the

leading edge of the media. The following illustration is an example, with

the operator viewing the front of the printer.

NOTE: Portrait orientation applies to PGL and VGL emulations. This is

regarded as Inverse Portrait using PPI/ZGL.

IBM InfoPrint 6700 Series User Manual

Questions and Answers: